Dreame DreameBot D10s Plus Manual De Usuario página 14

How to Use
EN
1. Fast Mapping
After configuring the network for the first time, follow the
instructions on the app to quickly create a map. The robot will
start mapping without cleaning. When the robot returns to the
base, the mapping process has been completed and the map will
be saved automatically.
2. Turn On/Off
Press and hold the button for 3 seconds to turn on the robot.
The power indicator should be illuminated. Place the robot onto
the base. The robot should turn on automatically and begin
charging. To turn off the robot, move the robot away from the
base and press and hold the
3. Start Cleaning
Press the button briefly to start cleaning after the robot is
turned on. The robot will accurately map out a route, methodically
clean along the edges and walls, then finish by cleaning each
room in an S-shaped pattern to ensure a thorough job.
12
button for 3 seconds.
4. Pause/Sleep
When the robot is running, press any button to pause it. If the
robot is paused for more than 10 minutes, it automatically enters
sleep mode. All indicators on the robot will turn off. Press any
button on the robot, or use the app to wake up the robot.
Note:
· The robot will turn off automatically if left in Sleep Mode for more than 12 hours.
· If the robot is paused and placed onto the base, the current cleaning task will end.
5. Do Not Disturb (DND) Mode
When the robot is set to the Do Not Disturb (DND) mode, the robot
will be prevented from resuming cleaning and the power indicator
goes out. The DND mode is disabled by default at the factory.
You can use the app to enable the DND mode or modify the DND
period. The DND period is 22:00-8:00 by default.
Note:
· The scheduled cleaning tasks will be performed on time during the DND period.
· The robot will resume cleanup where it left off after the DND period expires.
6. Spot Cleaning
When the robot is on standby, press briefly the
the spot cleaning mode. In this mode, the robot cleans a square-
shaped area of 1.5 × 1.5 meters around it and returns to its starting
point once the spot cleaning is completed.
button to enable