Publicidad
Raising/Lowering the Floor-tool
To raise the floor-tool, ensure the floor-tool carrier is central to the machine.
Lift the lever near the base of the handle and lock into position.
!
Always ensure that chemical manufacturer's safety guidelines are followed.
!
Do not operate machine unless the Operator Manual has been read
Machine In Use
To operate, set water flow rate tap, lower the floor-tool, press the vacuum / water switches, pull trigger(s).
The waste water is then retrieved by the suction floor-tool.
Overlap each scrubbing path by 10cm to ensure an even clean.
Do not operate the machine on slopes that exceed (2%),when full.
On heavily soiled floors use a 'double scrub' technique.
First pre-scrub the floor with the floor-tool in the raised position, allow the chemical time to work
then scrub the area a second time with the floor-tool lowered.
If streaking occurs wipe floor-tool blades clean.
NOTE: Care must be taken to reduce speed when cornering or
when manoeuvring around obstacles
WHEN HANDLING CHEMICALS
Only use chemicals recommended for use in auto scrubber-dryers.
IMPORTANT
and fully understood.
24
Machine Operation
!
!
Publicidad
