Publicidad
Idiomas disponibles
Idiomas disponibles
1. Make sure that the valve for the abrasive material
To operate the valve for the
is closed. Refer to
abrasive material on page 11 .
2. Open the the separator door.
3. Open the separator tray and remove all
contaminations when you fill abrasive material or
when it is necessary.
4. Fill the separator with abrasive material up to
the separator tray. Fill the separator with abrasive
material when it is necessary.
To connect a dust collector
WARNING:
collector if the dust collector hose is
damaged. The risk increases that you
breathe in dust that is dangerous to your
health. Use approved respiratory protection.
14
Do not use the dust
1. Examine the dust collector hose for damages.
2. Make sure that the filters in the dust collector are
clean and not damaged.
3. Attach the dust collector hose safely to the
connection for dust collector. Connect the dust
collector hose with hose clamps and industrial tape.
To connect the product to a power
source
1. Connect the power plug of the product to a grounded
mains outlet or other power source.
2. Make sure that the mains voltage agrees with the
type plate on the product.
To do a check of the direction of
rotation of the fan unit
1. Start the product. Refer to
page 15 .
2. After some seconds, stop the product. Refer to
stop the product on page 18 .
3. Make sure that the fan unit has the correct direction
of rotation. The correct direction is shown with an
arrow on the fan unit cover.
4. If it is necessary, change the phase sequence of the
power supply to change the direction of rotation of
the fan unit.
To select the correct speed
It is important to operate the product with the correct
speed for best result. If the surface has different quality,
adjust the speed for an equal result. Examine the result
and adjust the speed if it is necessary.
To start the product on
To
2111 - 001 - 21.07.2023
Publicidad
