Husqvarna EBE 350 Manual Del Usuario página 21

5. Put an applicable tool in the blast wheel blades to
prevent rotation. Remove the bolt and discard it.
6. Remove the impeller.
To install the impeller
1. Clean the threads of screw hole for the bolt for the
impeller with pressurized air.
2. Install the impeller.
2111 - 001 - 21.07.2023
3. Block the blast wheel blades with an applicable tool
and install the bolt for the impeller.
CAUTION:
CAUTION:
resistance when you install the bolt,
clean the threads of the screw hole. Do
not use force to install the bolt. It can
cause damage to the threads.
4. Install the 2 screws, the 4 washers, the 2 cage
clamps and the control cage.
5. Install the hopper. Refer to
hopper on page 20 .
To remove the blast wheel blades
CAUTION:
blast wheel, it is necessary to replace all 6
blast wheel blades at the same time.
1. Remove the hopper. Refer to
on page 20 .
2. Remove the control cage and the impeller. Refer to
To remove the impeller on page 20 .
Always use a new bolt.
If you feel unusual
To remove and install the
To prevent unbalance in the
To remove the impeller
21