Publicidad
Idiomas disponibles
Idiomas disponibles
10. Make sure that the impeller (B) and the control cage
(C) are correctly installed in relation to eachother.
C
B
11. Tighten the cage clamps.
12. Use your hands to rotate the impeller and the blast
wheel. Make sure that there are no unusual sounds.
13. Install the hopper. Refer to
hopper on page 20 .
To stop the product
1. Close the valve for the abrasive material. Refer to
operate the valve for the abrasive material on page
11 .
Introduction
WARNING:
maintenance, you must read and
understand the safety chapter.
WARNING:
equipment when you do servicing and
maintenance. Refer to
equipment on page 6 .
WARNING:
maintenance, stop the motors and
disconnect the power plug from the power
source. Make sure that all drives stop.
General product maintenance
Empty the dust collector.
18
C
B
To remove and install the
Maintenance
Before you do
Use personal protective
Personal protective
Before you do the
Each 3 h
*
2. Push the stop button for the blast motor (A), the fan
unit (B) and the drive motor (C).
3. Turn the ON/OFF switch to the OFF position.
4. Disconnect the power plug from the power supply.
5. Stop the dust collector. Refer to the operator's
manual of the dust collector.
To
For all servicing and repair work on the product, special
training is necessary. We guarantee the availability of
professional repairs and servicing. If your dealer is not
a service agent, speak to them for information about the
nearest service agent.
For more detailed information, refer to
www.husqvarnaconstruction.com.
Maintenance schedule
* = General maintenance done by the operator. The
instructions are not given in this operator's manual.
X = The instructions are given in this operator's manual.
O = The instructions are not given in this operator's
manual. Let an approved service agent do the
maintenance.
12 h after
Daily
servicing
A
B
C
Each 3
Yearly
months
2111 - 001 - 21.07.2023
Publicidad
