Publicidad
Idiomas disponibles
Idiomas disponibles
4. After 3 seconds, close the valve for the abrasive
material.
5. Operate the product 50 cm rearward.
6. Open the separator door and look if there is
remaining abrasive material. If there is remaining
abrasive material in the hopper, do the procedure
again until the hopper is empty.
To remove and install the hopper
1. Open the separator door and look if there is abrasive
material in the hopper. If there is abrasive material
in the hopper, empty it. Refer to
material from the hopper on page 19 .
2. Disconnect the power plug.
3. Loosen the clamp (A) on the abrasive valve.
A
4. Loosen the lever for the abrasive valve.
20
To remove abrasive
5. Remove 4 screws, the 8 washers, the 4 nuts and the
hopper.
6. Install the hopper in the opposite sequence.
To remove the impeller
1. Open the separator door and look if there is abrasive
material in the hopper. If there is abrasive material
in the hopper, empty it. Refer to
material from the hopper on page 19 .
2. Disconnect the power plug.
3. Remove the hopper. Refer to
the hopper on page 20 .
4. Remove the 2 screws, the 4 washers, the 2 cage
clamps and the control cage.
To remove abrasive
To remove and install
2111 - 001 - 21.07.2023
Publicidad
