Publicidad
Idiomas disponibles
Idiomas disponibles
General product maintenance
Do a check of the of the sepa-
rator and the separator tray.
Make sure that the power plug
and extension cable are in
good condition and not dam-
aged.
Do a check of the electrical
components, the cables and
the connections for wear and
damages.
Do a check of the Residu-
al Current operated Device
(RCD).
Examine the motors for dirt and
damage.
Make sure that the dust collec-
tor hose is not damaged and
that there is no blockage.
Do a check of the control cage
and blast wheel blades for
To do before you
wear. Refer to
operate the product on page
11 .
Clean the product.
Do a check of all safety devi-
ces.
Do a check of the brush list
seals and the front rubber seals
for wear.
Do a check of the V-belt ten-
sion.
Make sure that the nuts and
screws are tight.
Do a complete servicing and
cleaning of the product.
To clean the product
•
Always clean all the equipment after use. Use a
vacuum cleaner.
•
Do not use a high-pressure washer to clean the
product.
•
Keep the air openings clean and clear to make
sure that the product always has sufficiently cool
temperature.
2111 - 001 - 21.07.2023
Each 3 h
Daily
X
*
*
*
*
*
X
X
X
*
X
12 h after
servicing
*
To remove abrasive material from the
hopper
1. Start the product. Refer to
page 15 .
2. Push the ON button of the blast motor.
3. Push the OFF button of the blast motor when the
blast motor is at 75 % of maximum speed. At the
same time, open the valve for the abrasive material.
To operate the valve for the abrasive
Refer to
material on page 11 .
Each 3
Yearly
months
X
O
To start the product on
19
Publicidad
