Problem
The control system
does not start.
The control system
stops during opera-
tion.
Transportation
WARNING:
transportation. The product is heavy and can
cause injury or damage if it falls or moves
during transportation.
CAUTION:
behind a vehicle.
•
Disconnect the electrical cable and dust collector
hose before transportation.
•
Remove the abrasive material before transportation.
To remove abrasive material from the
Refer to
hopper on page 19 .
•
Put some type of protection on the product
during transportation. The protection keeps natural
elements, for example rain and snow, away from the
product during transportation.
To move the product up and down a
ramp
WARNING:
move the product up and down ramps. The
product is heavy and there is a risk of injury
if the product falls or moves too quickly.
WARNING:
slope, always use a winch. Do not walk or
stay below or near the product.
•
To move the product down a ramp, operate the
product forward slowly.
•
To move the product up a ramp, operate the product
rearward slowly.
26
Cause
The motor protection switch is engaged.
The power supply cable is damaged.
The cable between the product and the dust
collector is damaged.
The motor protection switch is engaged.
The dust collector stops because of over-
load.
Transportation, storage and disposal
Be careful during
Do not tow the product
Be very careful when you
For ramps with a steep
Solution
Start the product again. Do a check of the
power supply.
Replace the cable.
Replace the cable.
Let an approved electrician do a check.
Let an approved electrician do a check.
•
Do not turn the product to the left or to the right more
than 45° on a ramp.
To attach the product to a
transportation vehicle
Attach the product during transportation to prevent
accidents and damage to the equipment. Use tie-down
straps to attach the product to the transportation vehicle.
1. Put the product on the transportation vehicle.
2. Attach tie-down straps around the product.
3. Attach and tighten tie-down straps to the
transportation vehicle.
To lift the product
WARNING:
equipment has the correct specification to
lift the product safely. The type plate on the
product shows the product weight.
Make sure that the lifting
2111 - 001 - 21.07.2023