SICK Smart Light Tower SLT060-0B010J700 Instrucciones De Operación página 29

2 Safety information
2.1 General safety notes
2.1.1 Smart Light Buzzer
3 Intended use
8026183.1FJ5/2022-11-17 | SICK
Subject to change without notice
Read these operating instructions before commissioning the device.
■
■
Connection, mounting and configuration of the device must only be carried
out by qualified personnel.
■
NO
2006/42/EC
This device does not constitute a safety component as defined in the
SAFETY
Machinery Directive.
■
Do not install the device in places exposed to direct UV radiation (sunlight)
or other weather conditions unless this is expressly permitted in the operating
instructions.
When commissioning the device, ensure adequate protection against moisture
■
and contamination.
These operating instructions contain information required during the life cycle of
■
the device.
WARNING
• Please note that the SLB can produce a sound pressure level of 88 dB at a
distance of 1 m.
• Avoid exposing persons to the buzzer tone in close proximity for longer periods of
time. Non-observance can lead to irritation of the ear.
• If the noise level exceeds L
protective equipment must be worn to reduce the noise exposure.
• Please check your local requirements regarding noise protection.
The SLB enables an acoustic alarm to be issued when necessary. To ensure the SLB
alarm is audible over ambient noises, it is firstly possible to adjust the volume of the
SLB. Secondly, there are eight different sound effects available to ensure that the alarm
is audible even with loud ambient noises.
The Smart Light Tower SLT is used for the visual display of machine states or to indicate
filling levels.
The optional Smart Light Buzzer SLB unit is used for acoustic alarms.
Both the 20 LED segments and the acoustic Smart Light Buzzer SLB can be switched
on and off individually. Parameterization for this is done via the IO-Link interface.
Intended use requires that the device is used industrially indoors without any specific
climatic and atmospheric requirements. Any use outside of the areas mentioned in
each case will be considered to be incorrect use and void any warranty claims against
SICK AG. The intended use is only guaranteed if the housing is completely mounted.
In the event of any other usage or modification to the device (e.g., due to opening the
housing during mounting and electrical installation) or changes to the SICK software,
any claims against SICK AG under the warranty will be rendered void.
OPERATING INSTRUCTIONS
= 80 dB continuously (EU Directive), suitable
EX 8h
O P E R A T I N G I N S T R U C T I O N S | SLT
en
29