SICK Smart Light Tower SLT060-0B010J700 Instrucciones De Operación página 42

OPERATING INSTRUCTIONS
en
42 O P E R A T I N G I N S T R U C T I O N S | SLT
Group separation
Transfer values
Reset
Delete values
Configuration of limit val‐
ues
Animation repetition
Buzzer tab
The SLB alarm unit can be configured in the BUZZER tab. In addition to the volume,
various sound effects can also be set. The following sound effects are available:
Sound effect
1 Off
2 Continuous tone
3 Beeping
4 Whistling
5 Sweep
6 Beeping, slowly
7 Beeping, with pause
8 Whistling, with pause
9 Sweep, with pause
1) Pause: 500 ms on / 500 ms off
Alarm tab
Three user-defined light patterns (profile 1 to 3) can be configured in the ALARM tab. For
this purpose, an individual color sample can be created after selecting one of the three
profiles. The selection of patterns is done as with the regular color selection in the Color
tab. These three profiles can be selected for display on the STATUS page in all three
operating modes:
This function is only available in Signal lamp mode.
Activating the function turns off one LED segment between the
groups. This allows for better visual separation of the individual
groups.
This selection is only available in Signal lamp mode.
After changing the size of the individual groups in Signal lamp
mode, this configuration must be transferred to the SLT by clicking
the "Transfer values" button.
This selection is available in Signal lamp and Filling level mode.
Clicking on the RESET button resets the number of LED segments
in Signal lamp mode to the presetting. The limit values are reset in
Filling level mode.
This function is only available in Signal lamp mode.
By deleting the values, the number of LEDs in the changeable
groups is set to 0 and group 1 is then automatically set to 20.
In Filling level mode, a value between 0 and 100% can be set for
each LED segment. It is important to note that the value in each
LED segment may not be higher than the value in the segment
above it.
This selection can be used to set the repetition pattern of the
animation. The Loop (always building up from bottom to top) and
Bounce (first building up from bottom to top, then going down
from top to bottom) properties are available.
Description
Off
Continuous tone
Fast, periodic tone
Fast, high/low tone
Sweeping tone
Slow, periodic tone
Fast, periodic tone with pause
Fast, high/low tone with pause
Sweeping tone with pause
Frequency
3,378 Hz
3,378 Hz
2,016 Hz &
3,012 Hz
1,000 Hz &
4,032 Hz
3,378 Hz
3,378 Hz
1)
1) 2,016 Hz &
3,012 Hz
1,000 Hz &
1)
4,032 Hz
8026183.1FJ5/2022-11-17 | SICK
Subject to change without notice