ENGLISH
CAUTION: Check all parts are free from shipping
damage. In case of damage DO NOT use. Contact HH
Pressure Care or your supplier for further instructions.
Helping Hand Pressure Care recommends that a clinician such
as a doctor, therapist or rehab engineer experienced in seating
and positioning be consulted to determine if the cushion is
appropriate. Cushion should only be installed by:
• an authorised Helping Hand Pressure Care supplier
• a qualified healthcare professional who has undergone
appropriate training by either HH Pressure Care or their
approved supplier.
GENERAL WARNINGS!
• DO NOT install this equipment without first reading and
understanding this manual. If you are unable to understand
the Warnings, Cautions and Instructions, contact a qualified
clinician or supplier - otherwise injury or damage may occur.
• Installing a cushion on a wheelchair may affect the center of
gravity of the wheelchair and may cause the wheelchair to tip
backwards, potentially resulting in injury.
• Prior to prolonged sitting, any cushion should be tried for
a few hours at a time while a clinician inspects your skin to
ensure that red pressure spots are not developing. You should
regularly check for skin redness. The clinical indicator for tissue
breakdown is skin redness. If your skin develops redness,
discontinue the use of the cushion immediately and see your
doctor or therapist.
• Please note that no cushion can completely eliminate sitting
pressure.
• If you need more pressure distribution for skin protection, ask
your authorised supplier for a free demonstration of any of the
other JAY cushion products.
• None of the JAY cushions are a substitute for good skin care
including; proper diet, cleanliness, and regular pressure relief.
• Allow the cushion to warm to room temperature before
using. Sitting on extremely cold or hot surfaces can cause skin
damage.
• AVOID SHARP OBJECTS or exposure to excessive heat or open
flame.
• OBSTRUCTIONS: Do not place any obstructions between
the user and the cushion because it will reduce product
effectiveness.
• CUSHION AND COVER ORIENTATION: Product must be used
with the cushion cover facing up. If the cover is not used
correctly it may reduce or eliminate the cushion's benefits and
could increase risk to the skin and soft tissue.
UP
BACK
FRONT
DOWN
• When putting the cover back on please ensure the cover
has been put back onto the foam composite in the correct
orientation, and that the orientation compass is in the correct
place.
JAY Lowzone ECO | JAY Lowzone Switch | JAY Lowzone+ | JAY Lowzone GEL Switch | JAY GelZone | JAY ClimaZone
INTRODUCTION:
• Intended purpose of device: Lowzone Eco, Lowzone Switch,
Lowzone Gel Switch, Lowzone+, GelZone, ClimaZone are
designed for giving varying levels of pressure management,
postural control and microclimate regulation.
• The intended lifetime of this product is 5 years.
• Maximum user weight: Lowzone Eco, Lowzone Switch
114 kg, Lowzone Gel Switch, Lowzone+, GelZone 158 kg,
ClimaZone 254 kg
FITTING THE CUSHION
• Select a JAY cushion that matches the width of your
wheelchair.
• The cushion length should extend to within 25 – 50 mm (1"-
2") from the back of the knees.
• Adjust the footrests so your legs rest comfortably on the
cushion.
• Lowering the footrests on your wheelchair or seating device
may help reduce the pressure on your ischials, (seat bones)
and coccyx (tailbone).
NOTE: Proper footrest adjustment may enhance sitting
comfort.
Avoid using the cushion on overly stretched seat upholstery.
Replace stretched seat upholstery or purchase a JAY solid seat
insert for your cushion. Contact an authorised supplier for a
free demonstration.
EASY MAINTENANCE AND CLEANING
•
extend the life of your cushion. Check the cover for tears and
excessive wear.
• Cover: All covers can be machine washed. Please check the
labels on the individual cushion. Remove covers from foam
base before machine washing.
• Foam Base: Foam composites may be covered with a
polyurethane film. Providing this film has not been damaged,
clean with soft cloth moistened with water and a neutral
detergent. Foam base cleaning instruction in case of removing
the PU film: Wipe lightly with a damp cloth. Do not use soap
and do not submerge in water. Wipe off with a clean cloth and
let it completely air-dry before reassembly.
STORAGE
• DO NOT leave the cushion outside - extended exposure
to the elements could compromise the effectiveness of the
cushion.
• Store in a dry (moisture free) and clean environment when
not in use.
WARRANTY
ANY SIDE UP
All JAY cushions are guaranteed to be free from defects in
materials and workmanship for a period of 24 months from
the date of purchase, provided they are used correctly for the
purpose they were intended. This warranty does not apply
to punctures, tears or burns, nor to the cushion's removable
cover. The removable outer covers are guaranteed to be free
from defects in materials and workmanship for a period of six
(6) months from the date of purchase, provided normal use
Monthly cleaning and regular maintenance may help
.
3