Drexon BH-1701E Manual Del Usuario página 39

Then press , the time icon will flash. Use + and - to set the
time. Then press , the minute icon will flash. Use + and - to
set the minutes. Finally, press to confirm and finish setting the day
and time. The display alternates between the room temperature and the
current time.
IMPORTANT: after each setting, wait about 2 seconds to move on to the
next setting. This is the time required for the appliance to take the signal
into account.
Manual mode:
Press
- the heater will start up in 2000 W mode (the symbol will appear
on the display).
- Use + and - to set the desired temperature (from 5°C to 35°C). If noth-
ing is done for about 5 seconds, the desired temperature is automatically
stored. The display will return to showing the current room temperature
and time.
- Press once and the heater will operate in 1000 W mode (the
symbol will appear on the display).
- Press a second time and the heater will return to 2000 W mode.
- Press and the heater stops.
Note:
1. When the appliance is in standby mode, the screen goes blank. No
display is available.
2. In 2000W and 1000W mode, the set temperature must be higher than
the room temperature. Otherwise, the appliance will not start to heat up.
3. If the "frost protection" mode is selected, the temperature cannot be
changed.
4. Once the room temperature reaches the desired temperature, the ap-
pliance switches off automatically.
5. If the ambient temperature is about 2°C lower than the set tempera-
ture, the appliance will restart.
Rev 0_04 05 23 Fabriqué en Chine Page 39