Ecolab EcoPro Instrucciones De Servicio página 148

Start-up
7.2 Auto start function
DANGER!
Danger – automatic restart EcoPro
With AutoStart on, the pump automatically restarts when the power supply is
restored, without having to press a switch/button beforehand.
When AutoStart is on, the operator of the EcoPro is responsible for
taking suitable measures to ensure that an unwanted start-up of the
EcoPro is prevented when the mains power is restored after a power cut!
For safety reasons, the [AutoStart] function is not activated when the
EcoPro is delivered.
With [AutoStart], you can choose to have the pump "pause" when the mains connection is
re-established following a power cut, or if the pump should immediately restart in the set
mode.
7.2.1 Enabling Autostart with PCB '252050' or '252052'
1.
Press the [ON/OFF] button
ð Both LEDs light up briefly.
2.
Press the [ON/OFF] button
ð
The next time the pump is powered it will be in the saved mode.
If Autostart mode is not enabled, the pump is always OFF when the power
returns. If Autostart mode is enabled, the running pump is ON when the power
returns. If the pump was OFF before, it will be OFF again after the power
returns.
MAN046879 Rev. 12-12.2023
for approx. 1 second.
The pump must be switched off and there must be no fault (all LEDs are
off). If there is a fault, acknowledge this before switching off the pump.
– If the left LED lights up green, the pump is not set to Autostart!
– If the right LED is green, the pump is set to Autostart.
for approx. 1 second, while an LED is lit.
Press the [ON/OFF] button
Autostart mode.
The right LED now lights up instead of the left, or vice versa.
If the [ON/OFF] button
displayed mode is saved. The LED turns off.
, while a single LED is lit to switch to
is not pressed again within 5 seconds, the
46