Publicidad
Idiomas disponibles
Idiomas disponibles
Adjustment
3
Program the Travel
Without a properly installed safety reversal system, persons (particularly small children) could be SERIOUSLY
INJURED or KILLED by a closing garage door.
• Incorrect adjustment of garage door travel limits will interfere with proper operation of safety reversal system.
• After ANY adjustments are made, the safety reversal system MUST be tested. Door MUST reverse on contact with
1-1/2" (3.8 cm) high object (or 2x4 laid flat) on floor.
NOTE:
While programming the travel, the UP and DOWN buttons can be used to move the door as needed. During the
Automatic Force Setup, the door will automatically open and close.
1
Press and hold the
Adjustment Button until the
UP Button begins to flash
and/or a beep is heard. The
Safety Reversing Sensors
will be disconnected during
the Program the Travel
process.
3
Once the door is in the
desired UP position press
and release the Adjustment
Button. The garage door
opener lights will flash twice
and the DOWN Button will
begin to flash.
5
Once the door is in the
desired DOWN position
press and release the
Adjustment Button. The
garage door opener lights
will flash twice. Program
the Travel is now complete.
If the garage door opener
lights flash 5 times, then
programming has timed out and the Travel Limits
have not been set. Please restart the Program the
Travel process.
4
Automatic Force Set Up
Once both the up and down positions have been manually set, the Safety Reversing Sensors will reconnect and become
operational. Then, the opener will enter a force-sensing operation by automatically moving the door open and close. The
garage door opener will sound an audible and visual alert before automatically opening and closing the door. The garage
door opener will beep three times, confirming that the Automatic Force Setup completed successfully. Adjustment is
complete.
If you hear one long beep after the door attempts to move, then the Automatic Force Set Up has not completed
successfully. Please start over at step 1 of Program the Travel.
2
Press and hold the UP Button until the door is in
the desired UP position.
4
Press and hold the DOWN Button until the door is in
the desired DOWN position.
8
Publicidad
