Publicidad
Idiomas disponibles
Idiomas disponibles
5. Put backthe filter andreassemble t he front cover.
6. Plugin the icemakeror reconnect p ower.
DO NOT touch
condenser
fins.
They are sharp and
can be damaged
easily.
Water Distribution
Tube Cleaning
When you find that the ice cubes are incompletely
formed or the output of ice cubes is
low, the water distribution
tube may be blocked.
Set the ICE/OFF/WASH
switch to
OFF, rotate the water
distribution
tube, and locate the holes in the distribution
tube.
Using a toothpick
or similar tool, dredge the holes, then rotate the water distribution
tube
back to its original position.
If the tube is badly blocked, clean it as follows:
1. Shut offthe water supply.
2.
Disconnect
the water hose from the distribution
tube.
.
4.
Lift the right side, then remove the distribution
tube.
With a brush, clean the tube with a dilute solution of warm water and a
mild detergent
such as dishwashing
liquid. After removing
the dirt and lint
from the surface, rinse the tube with clean water.
5.
Replace the distribution
tube.
6.
Reconnect
the water supply.
Ice-Making
System
Cleaning
Minerals that are removed
from water during the freezing
cycle will eventually
form a
hard, scaly deposit
in the water system. Cleaning the system regularly helps remove the
mineral scale buildup. How often you need to clean the system depends upon how hard
your water
is or how effective
your filtration
may be. With hard water
of 15 to 20
grains/gal.
(4 to 5 grains/liter),
you may need to clean the system as often as every 6
months.
1. Make sure that all the ice is off the evaporator.
If ice is being made, wait until the
cycle is completed,
then turn the machine OFF at the ICE/OFF/WASH
switch.
2. Remove
all ice from the storage bin.
2O
Publicidad
