Publicidad
Idiomas disponibles
Idiomas disponibles
Troubleshooting
Before
Calling fi_r Service
If the unit appears to be malfunctioning,
read through
the OPERATION
section of this
manual first. If the problem persists,
check the Troubleshooting
Guide below and on the
following page. The problem
could be something
very simple that can be solved without
a service call.
Troubleshooting
Guide
Problem
The machine
doesn't operate.
The water doesn't
feed in after the ice
maker starts.
Machine makes
ice, but ice storage
bin does not fill up
with ice.
Water is leaking
from the unit.
Possible
Cause
The ice maker is unplugged.
The fuse is blown.
The ice maker power
switch is OFF.
The ice storage bin is full of
ice.
The drainage tray on top of
the compressor
is full.
The water supply tap is
turned off.
The water supply line is not
connected
properly.
Condenser
may be dirty.
The air flow to the ice
maker may be obstructed.
The ambient temperature
and water temperature
are
high, or machine is near
some heat source.
A few water drops tall to
the floor when you open the
door to take out ice from
the ice storage bin.
Water supply connection
leaking.
Probable
Correction
Plug the ice maker in.
Replace fuse. If it happens again, call
for service to check for a short circuit
in the ice maker.
Turn the ice maker power switch to
ICE (ON).
Remove some ice; make sure the
ice-full probe is free of ice.
Drain offwater by unscrewing lower
drainage nut.
Turn on the water supply tap.
Reconnect
the water supply line.
Clean the condenser.
Check the installation.
Check the installation.
Normal condensation
on the door or
some water together with ice. Take
care when you take out ice.
Tighten fitting.
See "Connecting
the
Water Line".
24
Publicidad
