Publicidad
1
2
3
1
Release loop tab
Languette en tissu de déverrouillage
Auslöseschlaufe
Holding tab receptacle
Réceptacle de la languette de retenue
Rastnasenschlitz
10
Snap fastener
Bouton-pression
Druckknopf
Holding tab
Languette de retenue
Rastnasenschlitz
Back
Arrière
Hinten
English
To install holding arms, first center the screw of the lower bracket on slot
in the shield, being careful to follow the correct angle as illustrated (1).
Pressing the arm and shield together firmly at the lower bracket, rotate both
inward to bring the upper shield hook into place as illustrated (2). With the
upper hook and lower bracket in place, slide the arm down until the upper
hook is in place and the curled end of the lower bracket locks into place
as illustrated (3).
WARNING:
Confirm that the curled end of the bracket is fully seated between the
shield and arm to prevent the shield and arm from becoming separated
unintentionally.
TO REMOVE/REPLACE EARCUPS
The earcups are secured to their base plates by upper snap fastener and
lower holding tab (1).
Fore
Avant
Vorn
Publicidad
