Publicidad
Idiomas disponibles
Idiomas disponibles
Installation
Instructions
CABINET PREPARATION
ITI PREPARINGFOR INSTALLATION
Positioning
the cooktop
The cooktop is designedto look best when centered in a
cabinet at least 30" wide.
The exhaust vent beneath the cooktop must be located
between wall studs or floor joists so that the ductwork may
be installed properly.
At least 6" must be allowed between side edges of the
cooktop and adjacent walls.
13"max. -- i_-t
depthof
/"
unprotected [11
overhead
15"min.height
cabinets
130" min.clearance
J
fromcountertop
I
from countertop
......J _
to nearestcabinet
L
to unprotected ........
l
oneithersideof
overhead surface.------- _
I
the unit
_J---r---"f_q
I
_"min.
tPJT
I
I
I clearance
frOm
II
I
I
I
I
cut°utt° side
lls
Avoid placing cabinets above the cooktop unit, if possible,
in order to reduce the hazards caused by reaching over
heated surface units. If cabinets are placed over the
cooktop, the riskscan be reduced by installing a range
hood that projects horizontally a minimum of 5 inches
beyond the bottom of the cabinets.
If cabinetry is used above the cooktop, allow a minimum
30" clearance between the cooking surface and the bottom
of any unprotected cabinet.
If the clearance between the cooktop and the cabinetry is
lessthan 30", the cabinet bottom must be protected with
flame retardant millboard at least 1/4" thick, covered with
28 gauge sheet steel or 0.020" thick copper.Clearance
between the cooktop and the protected cabinetry MUST
NEVER BE LESS THAN 2&"
EXCEPTION: Installation of a listed microwave oven or
cooking appliance over the cooktop shall conform to the
installation instructions packed with that appliance.
A 15" minimum must be kept from the side edge of the
cooktop to the bottom of any cabinet not directly above the
cooktop. If the clearance is less than 15", adjacent cabinets
should be at least 6" from the side edge of the cooktop.
I_1 PREPARING THE BASE CABINET
This cooktop is designedto fit easily into a variety
of cabinets. However,some cabinets may require
modifications.
Preparing a cabinet that is against a wall
In some cabinets, the sides may need to be scooped or cut
down 53/4 " as shown, and the corner braces removed in
order to accommodate the unit.
In 75 cm and 90 cm frameless European cabinets,
the back panel may need to be cut down 53/4 " to
accommodate the unit.
Preparing a peninsula or island-tgpe cabinet
In a peninsula or island-type cabinet, the sides may need to
be scooped or cut down, and the corner braces removed in
order to accommodate the unit.
53/4" A pprox.
for European
cabinets
[]
ROUGH PREPARATION
OF JUNCTION
BOX
IMPORTANT - FOR PERSONAL SAFETY,REMOVE
HOUSE FUSE OR OPEN CIRCUIT BREAKER BEFORE
PREPARINGJUNCTION BOX.
Install an approved junction box within shaded area
shown in diagram. Junction box must be at least
lOW' below top of cabinet.
Run conductors from residence wiring to junction box
according to local electrical codes.
16"
ct
9"
I
16
Publicidad
