GE PP989 Manual De Instrucciones página 24

Installation Instructions
INSTALLING THE COOKTOP
ATTACHING A BLOWER
TRANSITION DUCT
Use a blower transition duct for all downward duct
installations to connect to 6" round standard
ductwork. This 3VJ' x 10" rectangle to 6" round
transition duct is available at your local building
supply store.
Screw
(on other
side)
Remove the cardboard packing in the blower outlet.
Install the transition duct to the blower outlet. Secure
all joints with duct tape to assure an airtight seal.
I_] CONNECTING THE DUCTWORK
Connect the ductwork prepared in Steps 5 and 6 to
the blower transition duct.
BLOWER ELECTRICAL
CONNECTIONS
Loosen the two screws and remove and
discard the sheet metal strap covering the 5-pin
connector on the cooktop bottom. Save the
screws for reinstollotion later.
WS
II _/
anddiscardstrap
BLOWER ELECTRICAL
CONNECTIONS (cont.)
• Connect the 5-pin plug on the blower ossemblg
to the matching 5-pin receptacle on the bottom
of the wire enclosure.
5-pin
connectors
Fold all wires into the electrical enclosure. Secure
the enclosure with the screws removed earlier,
making sure that no wires are trapped.
5-pin
connectors
Electrical
II enclosure
_t,>_ = Flexible
conduit
24