cecotec BOLERO DRESSCODE 120700 A Manual De Instrucciones página 11

- Use the hose set supplied with the appliance. Do not reuse
old hoses.
- Check the hose connections and the tap to avoid problems
due to pressure changes. If the connections loosen or leak,
turn off the water tap. Do not operate the washer before
the hoses have been properly installed.
- Do not remove the filter from the drain pump while there is
water left in the machine. Hot water spillage may occur.
- Before carrying out any maintenance in the device, unplug
the appliance from the mains.
- As a safety measure, we advise you to unplug the appliance
and cut the water supply after every use. Maximum water-
inlet pressure: 1 MPa. Minimum water-inlet pressure: 0.05
MPa.
- Use the new hoses supplied with the equipment.
- Never unplug the appliance with wet hands.
- Unplug the power cord before cleaning or repairing the
product.
- For safety reasons, the appliance must be properly earthed.
- Water channelling and electrical devices must be
connected by a qualified technician in accordance with
the local and national safety regulations specified by the
manufacturer.
- The glass door may reach high temperatures during
operation. Keep children and pets away from the glass
door.
- Do not use the device in rooms where water, moisture,
explosives, or caustic gases are present.
- If the room where the washing machine is located has any
type of device that generates fumes from the burning of
fuels, make sure that there is proper ventilation, as the
accumulation of these fumes may cause a fire hazard.
BOLERO DRESSCODE 120700A
11