cecotec BOLERO DRESSCODE 120700 A Manual De Instrucciones página 87

ENGLISH
Connection of the inlet hose to the water supply
If the water inlet hose is not installed, it must be screwed to the appliance. The hose marked
blue is for cold water only. Hot water hose marked red must also be connected, for models
with double inlet.
10. Screw the hose by hand into the rear connector of the washing machine by tightening the
nut. Fig. 15
Legend Fig. 15:
1. Hot water (depending on the model)
2. Cold water
Warning:
1. Do not kink the hose!
2. The appliance must not be connected to the mixer tap of a non-pressurised water heater.
3. Check the tightness of the connections by opening the tap fully.
4. If the hose is too short, replace it with a hose of suitable length, with a minimum pressure
resistance of 1000 kPa.
5. Check regularly if the inlet hose is broken or cracked and replace it if necessary.
6. The washing machine can be connected without a check valve.
Connect the water supply inlet hose in accordance with Local Regulations.
Water tap: threaded ¾" hose connector
Drain hose connection
If the hose is installed as shown in figure 16, release it only from the right clip (according to
the arrow). Fig. 16
There are 3 ways to connect the drain hose:
1. In a drainpipe. It is recommended to use a vertical tube. Fig. 17
2. In a sink's drainpipe, over the trap. Fig. 18
3. Hook it over the edge of a sink using the U-bend. Fig. 19
NOTE: bend included only in certain models.
Place the U-shaped elbow, if it is not installed, in the end of the drain hose. Fig. 20
BOLERO DRESSCODE 120700A
87