ENGLISH
PANEL DUST FILTER CLEANING AND INTEGRITY CHECK
NOTE
Besides the standard paper filter, polyester filters are also available. The following procedure is applicable to each type of
filter.
1.
Drive the machine on a level floor and engage the parking brake with the pedal (75) and the lever (68).
2.
Turn the ignition key (67) to "0".
3.
Open the hood (22) and fasten it with the support rod (36).
4.
Disconnect the battery connector (25).
5.
Disconnect the vacuum system motor connector (30).
6.
Release the fasteners (A, Fig. 12) and remove the vacuum system cover (B).
7.
Disconnect the connector (A, Fig. 13) from the filter shaker.
8.
Unscrew the knobs (B, Fig. 13) and remove the filter mounting frame (C).
9.
Remove the dust filter (D, Fig. 13).
10.
In an outdoor area, clean the filter by shaking it on a level and clean surface, tapping the side (A, Fig. 14) opposite to the wire
gauze (B).
Complete the cleaning procedure by using compressed air (C) at maximum 6 Bar, blowing only from the side protected by the
wire gauze (B), at a minimum distance of 11.8 in (30 cm).
Check the filter body for tears.
According to the filter type, observe the following cautions:
•
Paper filter (standard): Do not use water or detergents to clean it, otherwise it can be damaged.
•
Polyester filter (optional): For a better cleaning, it is allowed to wash the filter with water and non-lathering detergents. This
provides better quality cleaning but reduces the life of the filter, which will have to be replaced more frequently. The use of
inadequate detergents can damage the filter.
11.
If necessary, clean the filter compartment rubber gasket (A, Fig. 15) along its perimeter and check it for integrity. If necessary,
replace it.
12.
Assemble the components in the reverse order of disassembly, and note the following:
•
Install the filter with the wire gauze (B, Fig. 14) facing upwards.
A
A
24
USER MANUAL
B
A
Figure 12
Figure 14
1463545000(1)2008-07
P100225
P100227
Terra™ 5200
Figure 13
Figure 15
P100226
P100228