Fuse Check/Replacement/Reset - Nilfisk-Advance Terra 5200 B Instrucciones De Uso

FUSE CHECK/REPLACEMENT/RESET

1. Drive the machine on a level floor and engage the parking brake with the pedal (75) and the lever (68).
2. Turn the ignition key (67) to "0".
3. Open the hood (22) and fasten it with the support rod (36).
4. Disconnect the battery connector (25).
Lamellar fuse check/replacement
5. Remove the cover (A, Fig. 28) and mark the positions of the fuses shown on the adhesive.
6. Check/replace the relevant fuse among the following (B):
• F1 fuse (30 A): Key circuit
• F2 fuse (30 A): Filter shaker
• F3 fuse (30 A): Vacuum system
• F4 fuse (30 A): Hydraulic pump
• F5 fuse (10 A): Flashing light (optional)
• F6 fuse (10 A): Working light (optional)
• F7 fuse (10 A): Hopper actuator
• F8 fuse (30 A): Spare fuse
Main fuse check/replacement
7. Remove the screws (C, Fig. 28), then remove the cover (D).
8. Remove the nuts (E).
9. Check replace the main fuse F0 (150 A) (F)
Circuit breaker check
10. Check for deactivation of one of the following fuses, then reset it after the relevant motor has cooled down:
• FA fuse (H, Fig. 28): Right side broom motor circuit breaker
• FB fuse (I): Left side broom motor circuit breaker
• FC fuse (G): Main broom motor circuit breaker
Assembly
11. Assemble the components in the reverse order of disassembly.
Figure 28
Terra™ 5200 1463545000(1)2008-07
USER MANUAL ENGLISH
S311447
29