BURNHARD FLINT Manual página 21

ASSEMBLING THE PELLET CHAMBER
7
Place the funnel onto the pellet chamber. Make
sure that the lid opens to the front side (operating
element).
ATTACHING THE GRILLING CHAMBER
9
13
Place the grilling chamber onto the base
cabinet. Make sure that the chamber is
located between the left and right-side
panels.
10
Screw the grilling chamber onto the side
panels.
8
Open the lid and insert the pre-assembled screws
into the cap nuts through the holes in the funnel
from the outside. Tighten from the inside.
1
AA
4
40
ATTACHING THE PELLET CHAMBER
11
Connect the RTD connector from the inside of
the grilling chamber to the counter plug on the
outside. Warning: Any excess wire of the RTD plug
should be located outside of the chamber.
12
13
AA
12
Slide the combustion chamber into the grilling
chamber using the provided opening.
13
Open lid of the grilling chamber and fasten the
combustion chamber from the inside with preas-
sembled screws.
11
41