Publicidad
Idiomas disponibles
Idiomas disponibles
7. 6 . FO R K & ST E M A S S E M BLY
„
Install the front end (fork, headset, headset spacers, stem, handlebar, wheels) on the frame
then determine the rider's fit. Don't install more than 30 mm of spacers between the stem
and the headset cover (FIG. 6).
„
Trim the steerer tube so the final cut is 3 mm below the top of the stem (or 3 mm below the
top of the spacer if a 5 mm spacer is used).
4
FIG. 4
Install the expander plug (A) into the steerer tube (B). Using a 6 mm hex bit, torque the plug
„
to 9 Nm / 80 in-lbf.
15
A
B
5
G
E
D
A
B
C
FIG. 5
„
When installing the headset for the final assembly, grease the compression ring (A), the
upper bearing (B), and the lower bearing (C).
„
Install the headset cover (D), spacers (E) and stem (F), followed by the top cap and bolt
(G). Using a 4 mm hex bit, torque the bolt to apprximately 1-2 Nm / 9-18 in-lbf.
F
Publicidad
