Corghi ET88 Manual De Uso página 77

- Check the value measured and then return the arm to the rest position. The
machine now prepares for input of the width.
If an incorrect value has been acquired during the measurement operation, move
the arm to the rest position and then repeat the operation.
- Measure the width of the rim using the special calliper (fig. 15).
- Modify the width value displayed by pressing the
the number required,
- Press the key to confirm the value entered.
The WIDTH can be set in millimetres, or values already set can be converted from
inches to millimetres by selecting the width input in millimetres icon
- Select the
if the measurement is available in mm.
- Modify the diameter value displayed by pressing the arrow keys
set the number required.
The or arrow keys can be kept pressed for rapid increase or decease of
the values set previously.
- Press the key to confirm the value entered.
- To conclude the wheel data input phase, select the
a wheel spin.
If the automatic measuring arm fails to operate, the geometrical data can be
entered in manual mode by following this procedure.
- select the icon
- the video page for manual setting of the data appears on the screen. It contains
the following icons:
Enter width in inches: enables entering of the rim width in inches.
Enter width in millimetres: enables entering of the rim width in
millimetres.
Enter diameter in inches: enables entering of the rim diameter in
inches.
Enter diameter in millimetres: enables entering of the rim diameter
in millimetres.
ET 88 operator's manual
icon for input of the diameter in inches or the
in the utility submenu (
or arrow keys and set
or
Exit icon or perform
)
.
icon
and
GB
77