Corghi ET88 Manual De Uso página 78

Enter distance in millimetres: enables entering of the distance
between the rim and the machine body in millimetres.
Exit: returns the program to the video page with the imbalances.
Help : shows the help information relating to the manual setting of
data.
- After selecting the icon, press the
appears in the box relating to the parameter to be entered.
- Press the
- Select a new icon to set another parameter.
- To stop manual data setting, press the
The values to be set are the nominal values of the rim; for the distance, simply
read the value indicated on the graduated rule of the sensor after it has been
placed in contact with the inside of the rim (fig. 12a).
If the width of the rim is not known, measure it using the caliper provided (fig. 13).
The wheel spin operation is started by pressing the START key.
WARNING
If, due to a fault on the machine, the wheel keeps spinning permanently, switch
off the machine at the master switch or unplug the plug from the power supply
panel (emergency stop).
USING THE WHEEL SHAFT LOCK
The wheel shaft lock is used to simplify fitting and removal of wheels using the
relative centring accessories, and during application of the balancing weights.
To activate the lock device, press the STOP button (the red one).
The wheel is released:
- by pressing the STOP button again;
- by performing a wheel spin;
- after 30 seconds.
Pressing the STOP button with the wheel in motion stops the wheel spin before
completion.
78
key to confirm the value.
WHEEL SPIN
and arrow keys until the value required
Exit icon.
ET 88 operator's manual