Publicidad
NOTES
Unpack the Lights. Check the box thoroughly for all hardware and loose parts. Carefully inspect the fixture for damage.
DANGER:
Risk of personal injury. To avoid possible electrical shock, the electricity must be turned off at the circuit
breaker or fuse box before attempting any installation procedure.
DANGER:
Risk of personal injury. To avoid possible electrical shock, the light fixture must be properly grounded.
CAUTION:
metal permanent wiring system or an equipment-grounding conductor must be run with the circuit conductors and connected to the
equipment-grounding terminal or lead on the product. All wiring should be done by a qualified licensed electrician.
IMPORTANT: Power for the lights should be provided separately from the electricity to the cabinet so that when lights are turned off,
cabinet electricity remains on.
NOTE: Requires minimum 120 VAC 15 amp circuit.
Observe all applicable electrical codes and building codes. Wire the light fixtures in accordance with the electrical codes.
This fixture is for indoor use only.
This installation may require the assistance of more than one person depending on your Light/Cabinet configuration.
DISCONNECT POWER BEFORE INSTALLATION
© 2022 Robern, Inc. 701 N. Wilson Ave. Bristol, PA 19007 U.S.A.
800.877.2376
www.robern.com
Grounding instructions for permanently connected products: This product must be connected to a grounded,
DANGER - RISK OF SHOCK -
4
Part no. 209-1426 || 09-MAY-2023
Inline™ Tunable Light
Publicidad
