OHAUS Endeavor 5000 Serie Manual página 18

EN-16
Reset Timer to Zero
1. Rotate Time Adjustment Knob (D) so either minutes or hours are blinking
2. Press and hold Time Adjustment Knob (D) until 00:00 is on timer display
Adjust Set Speed
1. Rotate the Speed Adjustment Knob (E, Figure 1) to the desired setting
2.3. Shake Mode
Start Shake Function
•
1. Press and hold the Speed Adjustment Knob (E) until the unit beeps and the Run Status
Indicator (C, Figure 1) illuminates.
Adjust Speed while shaking
•
1. Rotate the Speed Adjustment Knob (E)
2. The Run Status Indicator Light (C) will blink indicating the unit is ramping to the new speed
setting.
3. Once the unit reaches the new speed setting the Run Status Indicator Light (C) will be
illuminated and stop blinking
Adjust Remaining Time (count down only when timer is set)
•
1. Rotate the Time Adjustment Knob (D) to adjust the minutes value. The minutes value will blink
while making adjustment.
2. Quick press the Time Adjustment Knob (D) to confirm the minutes value, and now the hours
value will blink.
3. Rotate the Time Adjustment Knob (D) to adjust the hours value
4. Quick press the Time Adjustment Knob (D) to confirm hours value and the new timer setting
NOTE: When making adjustments and the minute or hour is blinking; if the time setting remains
idle without confirmation for 6 seconds it will reset to the current setting.
Stop Shake
•
1. Press and hold the Speed Adjustment Knob (E) until the unit beeps and the Run Status
Indicator Light (C) turns off
Endeavor 5000 Series