OHAUS Endeavor 5000 Serie Manual página 25

Endeavor 5000 Series
Factory Reset
Resetting the unit to Factory Default Settings will do the following:

o Clear all programs
Clear all recall parameters
o
Clears all System settings to the default value
o
Navigate to the System Settings submenu ("SYS")

Navigate to the Reset setting ("rSt")

Quick press to select value (no or yes)

Rotate knob to select the desired setting

Quick press to confirm

2.6. RS232
RS-232 serial port provides two-way communications for data logging and unit control by means of a PC and a
suitable application program.
Interface connections chosen in accordance with EIA standard RS-232
•
• Device Connector: RS-232 DB9 Female
Recommended Cables:
•
o DB9 M/M Straight Through Serial Cable
USB-A to RS-232 DB9 Straight Through Serial Adapter Cable
o
Transmission Procedure
•
o Asynchronous character transmission in start-stop mode
Transmission Type
•
o Full Duplex
Character Format
•
o Start Bit(s): 1
Character Bits: 8
o
o Parity Bit(s): None
Stop Bit(s): 1
o
Transmission Speed (Baud Rate): 9600
•
• Data Flow Control: Xon/Xoff
Syntax
•
o Instructions and parameters separated by space (0x20)
o CR LF termination (0x0D, 0x0A)
o Max length: 80 characters
'<command> A' returned if the command is recognized; 'L' returned otherwise.
•
EN-23