OHAUS Endeavor 5000 Serie Manual página 5

Endeavor 5000 Series
1.2. Intended Use
This instrument is intended for use in laboratories. It must only be used for processing materials as described in
these operating instructions. Any other type of use and operation beyond the limits of technical specifications,
without written consent from OHAUS, is considered as not intended. This instrument complies with current industry
standards and the recognized safety regulations; however, it can constitute a hazard in use. If the instrument is not
used according to these operating instructions, the intended protection provided by the instrument may be
impaired.
1.3. Package Contents
• Light Duty Shaker or Microplate Shaker
• Power cord
• Power supply
• Non-skid rubber mat (Light Duty Shaker only)
• V-clips and springs to secure microplates (Microplate Shaker only)
1.4. Installation
Upon receiving the Ohaus Light Duty/Microplate Shaker check to ensure that no damage has occurred during
shipment. It is important that any damage that occurred in transport is detected at the time of unpacking. If you do
find such damage, the carrier must be notified immediately.
After unpacking, place the Light Duty/Microplate Shaker on a level bench or table, away from explosive vapors.
Secure to an immovable work surface by pressing down on the four (4) corners of the unit, creating a strong
suction to the work surface (DO NOT place on a bench mat or press on the tray). Do not position the equipment
such that it is difficult to disconnect the power cord during use. Always place the unit on a clean and sturdy work
surface.
Plug the power supply provided with the Light Duty/Microplate Shaker into the power jack on the back of the unit.
Only use the power supply provided with the unit. The Light Duty/Microplate Shaker is supplied with a 3 conductor,
grounded power cord. Connect to the provided power supply to the power cord and plug the power cord into a
standard grounded outlet.
If the cord supplied does not meet your needs, please use an approved power cord that has ratings equal to or
exceeding those of the originally provided cord and that complies with the local/national regulations of the country
in which the equipment is to be used.
EN-3