Descargar Imprimir esta página

Nuova Simonelli OSCAR II Instrucciones De Manejo página 26

Ocultar thumbs Ver también para OSCAR II:

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

SAFETY
INDICATIONS
1. INSTALLATION
The present manual is an integral and essential
part of the product and is to be delivered to the
user. Carefully read all warnings in the manual
as they provide important information required
to install, use and maintain the unit safely.
Keep this manual in a safe place for further
consultation.
After having removed the packaging, make cer-
tain that the unit is not damaged in any way.
If you have any doubts, do not use the unit and
contact a professionally qualified person. Always
keep all packaging (plastic bags, polystyrene
foam, nails, etc..) out of the reach of children as
they are a potential source of danger and never
loiter the environment with such materials.
The machine is can be installed in staff kitchen
areas in shops, offices and other working envi-
ronments, farm houses by clients in hotels,
motels and other residential type environments
bed and breakfast type environments.
Before turning on the unit make certain that
the rating indicated on the label matches the
available power supply. The nameplate can be
seen inside the machine when removing the
water collection tray.
The machine must be installed according to the
applicable federal, state and local standards
(codes) in force with regard to plumbing sys-
tems including back-flow prevention devices.
For this reason, the plumbing connections must
be carried out by a qualified technician.
The warranty expires if the characteristics of the
power supply do not correspond to the name-
plate data.
The manufacturer cannot be held responsible
for any damages incurred if the system is not
grounded.
For electrical safety, this machine requires a
ground system. Contact a technically certified
electrician who must check that the line electri-
cal capacity is adequate for the maximum
capacity indicated on the unit label.
The qualified electrician must also check that
the section of the installation's cables is large
enough for the absorbed power of the appli-
ance.
Never use adapters, multiple jacks or extension
cords.
26
When such items prove absolutely necessary,
call in a qualified electrician.
When installing the device, it is necessary to
use the parts and materials supplied with the
device itself.
Should it be necessary to use other parts, the
installation engineer needs to check their suita-
bility for use in contact with water for human
consumption.
The installer must Make the hydraulic connec-
tions respecting the rules of hygiene and water
safety to environmental protection in force in
the place of installation.
So for the hydraulic plant contact an authorized
technician.
Always utilise the new hose supplied for connec-
tion to the water supply. Old hoses must not be
utilised.
The device needs to be supplied with water that
is suitable for human consumption and compli-
ant with the regulations in force in the place of
installation. The installation engineer needs
confirmation from the owner/manager of the
system that the water complies with the require-
ments and standards stated above.
This unit must only be used for the purposes
described in the present manual. The manufac-
turer cannot be held responsible for any damag-
es caused by improper, mistaken and unreason-
able use.
The appliance is not to be used by children or
persons with reduced physical, sensory or men-
tal capabilities, or lack of experience and knowl-
edge, unless they have been given supervision
or instruction. Children must not play with the
appliance. Cleaning and maintenance must not
be carried out by children unless supervised.
This appliance is for professional use only.
The operating temperature must be within the
range of [+5, +35]°C.
At the end of installation, the device is switched
on and taken to rated operating conditions,
leaving it in a state in which it is "ready for
operation".
After reaching the "ready for operation" condi-
tion, the following dispensing operations are
carried out:
• 100% of the coffee circuit through the coffee
dispenser (for more than one dispenser, this is
divided equally);
• Open the steam outlet for 1 minute.
At the end of installation, it is good practice to
draw up a report of the operations.
Before using the machine, read this manual in
its entirety or, at the very least, read the safety
and set up instructions.
There are some basic rules for the use of any
electrical appliance.
In particular:
Never touch the unit with wet hands or
feet;
Never use the unit with bare feet;
Never use extension cords in areas
equipped with baths or showers;
Never pull on the power supply cord to
unplug the unit;
Never leave the unit exposed to atmos-
pheric agents (rain, direct sunlight, etc..);
Never let children, unauthorized person-
nel or anyone who has not read this
manual operate the unit.
When the machine is left unattended for
a long period, close the water inlet tap.
Before performing any sort of maintenance, the
authorized technician must turn off the unit and
unplug it from the mains.
2. CLEANING AND MAINTENANCE
Before cleaning the unit set it in a state of "0"
energy that is, "MACHINE SWITCHED OFF AND
UNPLUGGED". Follow the instructions given in
this manual carefully.
Refer to chapters 6 and 7 for periodical cleaning
and maintenance.
Once started the washing machine, do not inter-
rupt, the detergent residue may remain inside
the delivery unit.
In case of breakdown or poor function, turn off
the unit.
Never tamper with the unit. Contact only pro-
fessionally qualified personnel.
Only the manufacturer or an authorized service
center can make repairs and only using original
spare parts.
Non compliance with the above can compromise
machine safety.
On installation, the qualified electrician must fit
a circuit breaker switch as foreseen by the safe-
ty norms in force that has a contact open dis-
tance that permits the complete disconnection
under conditions of overload category III.
To prevent dangerous overheating, it is advisa-
ble to fully extend the power supply cord.

Publicidad

loading