To Insert Needles (S); Presser Foot Lift; Change Presser Foot - JUKI MO-80CB Manual De Instrucciones

(3) TO INSERT NEEDLES (S)

* Hold the needle with the flat surface to the back.
* Insert the needle into the needle socket as far as it
will go.
* When inserting a needle, if you first lower it down
into the hole in the stitch plate it will line up with
the needle socket. Then direct it upwards.
Note : When inserting needles into the A or B
sockets it is necessary to loosen both A & B
allen Screws. After inserting the needles
equally tighten both screws*
This machine uses ELx705 needles. Do not use
Standard Household Needles.

11. PRESSER FOOT LIFT

* Raise the presser foot by left down presser foot lift
lever at the left side of the machine.
* Take down the presser foot lift lever down
the presser foot in the extra lift position.

12. CHANGE PRESSER FOOT

Turn off the main power switch and unplug
the machine.
* Raise the presser foot.
* Turn the hand wheel toward you until the needles
are at the highest position.
* Push the red button on the back of the presser
foot ankle to release the presser foot.
* Raise the presser foot to the extra lift position and
the foot will come off.
* Place the new foot with the pin right underneath
the groove of the ankle while in the extra lift
position.
* Lower the presser foot. Push the red button on the
back of the presser foot ankle and the foot will
snap into place.
31
To tighten
To loosen