CYBEX gold SIRONA G i-Size Guia Del Usuario página 12

4. Push the ISOFIX-Locking arms (6) out of the base to their furthest extent.
EN
5. Place the base (7) on an appropriate seat in the vehicle.
6. Push the ISOFIX-Locking arms (6) into the ISOFIX-Anchorage points
(8) until these lock into place with an audible "CLICK". The two ISOFIX-
Indicators (9) will switch from RED to GREEN.
7. Ensure the base is secure by trying to pull it out of the ISOFIX-Anchorage
points (8).
8. Push the Base (7) towards the backrest of the vehicle seat until it is fully
aligned with the backrest.
Moving the base from side to side will also brace it against the vehicle
��
backrest.
9. Press the Load leg adjustment button (10) and extend the leg until it
touches the vehicle floor.
10. Pull the Load leg (4) out to the next locking position to ensure optimal force
transmission.
11. The Load leg indicator (11) switches to GREEN when the load leg is
correctly positioned on the vehicle floor and the acoustic warning signal
stops.
12. Place the car seat on the Base (7).
13. Please ensure that the car seat locks into place with an audible "CLICK".
14. Check whether the Seat locking indicator (12) on the base is GREEN.
REMOVAL FROM THE VEHICLE
1. To unlock the car seat from the base (7) pull the seat release handle (13)
up.
2. Tilt the seat slightly and lift it off the base (7).
3. Unlock the ISOFIX-Locking arms (6) on both sides by pressing the ISOFIX-
Release buttons (5) and at the same time pulling them back.
4. Pull out the Base (7) from the ISOFIX-Anchorage points (8).
5. Remove the Base (7) and slide the ISOFIX-Locking arms (6) completely
back into their transport positions.
6. Push the Load leg (4) back into its original position and then fold it in to
save space.
8
ADJUSTING THE HEADREST
The adjustable Headrest (14) can be adjusted by using the Headrest
adjustment handle (15) at the back of the Headrest (14). When adjusting the
headrest ensure that the Shoulder harness outlets are at shoulder level or
slightly below.
ROTATION FUNCTION
Pull the seat rotation handle (16) on the base to turn the car seat.
Before starting your journey, make sure that the seat is properly locked into
place and the driving direction indicator (17) shows GREEN.
As soon as your child is older than 15 months and taller than 76 cm, it can also
be transported forward facing. For this purpose, set the direction control button
to the top position.
The car seat can be used rear-facing for its entire child size range .
��
ADJUSTING THE RECLINE POSITION
To adjust the seat to the recline position, press the Position adjustment handle
(18) on the front of the car seat.
We recommend using the flattest recline position for children who are not
��
yet able to sit recline independently.
�� Always make sure that the car seat audibly clicks into place when adjusting
it to either the recline or sitting position.
SECURING THE CHILD
1. Rotate the car seat to the boarding position.
2. Press the Belt adjustment button (19) and pull both Shoulder belts (20) at
the same time to loosen them.
3. Undo the Belt buckle (21) by pressing the red button firmly.
4. The Buckle tongues (22) can now be attached to the indicated places on
the cover using the integrated loops.
5. Put your child in the car seat with their buttocks at the back.
6. Place the Shoulder belts (20) directly over your child's shoulders.
7. Place both Buckle tongues (22) together and lock them in place in the Belt
buckle (21). You should hear an audible "CLICK".