Publicidad
Idiomas disponibles
Idiomas disponibles
them.
- Keep the auger vertical, do not twist it!
- Always secure the holes, otherwise there is a risk of injury.
- Drill holes in the ground exclusively with the auger. Other applications are not allowed.
Engine starting
If the engine is cold, turn the choke lever (C) to position
If the engine is warm, turn the choke lever (C) to the position
Prime the fuel pump (16) by pressing it several times until you can see fuel in the pump.
Place the stop switch (11) in the "start" position.
Lightly pull the starter cable (9) until resistance is felt, then pull the cable firmly 2-3 times until
the engine starts briefly.
DANGER
Do not pull out the starter cable more than approx. 50 cm, and lead it back by hand. For
efficient starting, it is important to pull the starter cable quickly and powerfully.
Turn the choke lever (C) to
Pull the starter cord 2-3 times again until the motor fires and runs in idle mode.
ATTENTION!
The earth auger only begins to rotate when the throttle lever is used.
Stop the engine
Press the stop switch (11) in the 'Stop' position.
When restarting, first press the stop switch (11) back to the 'Start' position.
Before starting the motor, check the following:
Fuel level - the fuel tank should be at least half full
Condition of the fuel lines
Outer screw couplings for tight fit
The earth auger has to be able to run freely
Operating
Set the auger down and actuate the throttle control lever (13).
Adjust the power according to the ground conditions in order to be able to proceed ideally.
ATTENTION!
When leaving the auger, the motor must always be turned off.
position
..
.
Owner´s manual
.
.
English
39
Publicidad
