6- Conductivity Kit; Technical Characteristics; Hydraulic Installation; Wire Connection - filtreau BSONE-EVO-10 Manual De Usuario

By installing this kit, you will also be able to use the semi-automatic control
mode. More details on this mode can be found on the 4.2 chapter in this
manual.

3.2.6- CONDUCTIVITY Kit

The Conductivity Kit from BSPOOL performs a continuous
measurement of your Swimming pool's water chloride. It is
specially suitable to work with salt water chlorination Systems,
and it will allow to know the salt concentration in the water, and
also the electrolysis cell condition.
This sensor is been designed to work with BSPOOL Systems
exclusively. In order to confirm the compatibility with your
BSPOOL chlorinator model, please, ask to your distributor.

3.2.6.1 Technical characteristics

- Sensor technology: Inductive, with temperature compensation
- Measurement range: 0 to 10g/l
- Resolution: 0,1g/l
- Supply: 12V DC
3.2.6.2 Installation

3.2.6.2.1 Hydraulic installation

- This sensor must be installed after your Swimming pool's filter,
before the electrolysis cell. The mínimum distance between the sensor
and the electrolysis cell is 50cm.
- Install a 1"1/4 flange (not supplied) according with the pipe
diameter where it will be installed.

3.2.6.2.2 Wire connection

Once the conductivity sensor is installed, should
be connected to the electrolisys unit as follows:
69 / 95
Manual BSONE-EVO v.2