filtreau BSONE-EVO-10 Manual De Usuario página 82

- Acid: Select this mode if you are going to inject pH reducer into the
swimming pool (default mode).
- Alkaline: Select this mode if you need to inject pH increaser into the
swimming pool.
Access this option from the "Configuration menu". To change this mode to
another one, press OK and confirm the change of mode by selecting "S" and
then press OK again.
Note: Password "1234" is required to modify this function.
4.1.4.9- pH Alarm
The pH adjustment system will give an alarm and the dosing pump will stop
operating when the pump works continuously for more than 2 hours,
This could occur for the following reasons:
- The acid tank is empty and therefore pH corrector is not being injected
into the swimming pool.
- The pH probe is dirty or worn, and cannot read the real value correctly.
However, what could occur, particularly when starting up the equipment for the
first time, is that the real pH of the water is a long way from the set value. The
alarm can be disabled if it is calculated that the pump needs to work
continuously for several hours to correct the pH. However it is recommended to
enable the alarm once values near the set values are reached.
Note: Password "1234" is required to modify this function.
4.1.4.10 Chloride Alarm
When the unit is configured in automatic mode, it is possible to disable the
"Chloride Alarm". This alarm will detect if the ORP or PPM reading hasn't
changed for two hours or more, despite the unit has been in production.
Despite this alarm is been implemented to detect if a probe is not in good
conditions, or there is some chemical issue in the water, it can be disabled if
the user wants to maintain the production despite everything.
Note: Password "1234" is required to modify this function.
Manual BSONE-EVO v.2
82 / 95