Descargar Imprimir esta página

Greencut GS2500 10 Manual De Instrucciones página 68

Publicidad

Idiomas disponibles

Idiomas disponibles

68 I EN
CHAIN OIL
Use engine oil SAE #10W-30 during all the year or SAE #30 - #40 in summer and SAE #20 in winter.
Note
Never use wasted or regenerated oil as this can cause damage to the oil pump.
Note
Remember! The chain regulation controler can only turned 1/4 (right or left) on the
contrary, if you turn it more, you may brake the limit.
ENGINE OPERATION
It is very dangerous to operate a chainsaw when its components are damaged or missing.
Before starting the engine, make sure that all components, including the bar and chain are installed
properly.
IGNITION
1. Fill the fuel deposit and the chain oil. Adjust lids.
2. Press constantly priming bulb until fuel reaches the bulb.
3. Place the switch in the "I" position.
4. Pull the choke knob out to second. The throttle will close and the throttle will start position.
Note
When the engine starts immediately after stopping, leave the choke knob in the
open position. After pulling the choke knob out, it will return to the operating
position even when you press down with your finger. To return the choke knob to
the operating position, pull out the throttle.
5. With the saw unit securely on the ground, pull the starter rope firmly.
Never try to start the engine holding the machine with both hands. This is extremely
dangerous, as the chain can touch your body.
6. Once ignition occurs, press the throttle to enter to the first position again and pull the
starter rope to start the engine.
7. Let the engine warm up keeping the throttle slightly pulled.

Publicidad

loading

Este manual también es adecuado para:

Gs2500 12Gs2500 carvin