System Selection And Reset Procedure; Cycle Defaults Table - Pentair 368 Manual De Instrucciones

System Selection and Reset Procedures
The 604/606 control has four system settings available. The system selections accommodate
multiple tank sizes and various feedwater water conditions. Please contact your installer before
changing system settings.
System Selection:
1. Press and hold the and buttons simultaneously for 3 seconds.
2. A small "u" will be displayed in the left digit. The right digit will display the current system setting.
3. Press the button to scroll through the system settings. Release the button when the
desired system setting is displayed.
4. T he displayed system setting will be stored in Flash memory when the control exits program-
ming after 5 seconds.
System Selection Reset:
All programmed settings with the exception of Time of Day can be reset. Entering the value "0"
will reset the flash memory to the factory default.
1. Press and hold the and buttons simultaneously for 3 seconds.
2. A small "u" will be displayed in the left digit. The right digit will display the current system
setting.
3. Press the button and scroll the display to the "u 0" display.
4. W ait 5 seconds for the setting to be stored into flash memory. The display will revert to the Time
of Day setting. The control has now defaulted to System 1 setting.
5. F ollow steps 1-4 of the System Selection Procedure to select the desired system setting.
Programmed Settings
C# Cycle
Backwash
C1
Brine Draw
C2
Slow Rinse
Repressurize
C3
C4
Fast Rinse
2nd Backwash
C5
C6
2nd Fast Rinse
C7
Brine Refill
Pentair Residential Filtration, LLC
Resin
System u1 System u2
Bed Flow
(minutes) (minutes)
Direction
8
↑
Calculated Calculated
25
None
3
3
↑
1
1
None Calculated Calculated
System u3 System u4
(minutes) (minutes)
8
1
Calculated Calculated
45
25
3 3
3 1
1 1
1 1
Calculated Calculated
3
45
3
3
1
1
15
Rev B