Reiner 880 Manual De Instrucciones página 78

REINER 880
Select desired step with the buttons [t] or [u].
f
To confirm the input, push [OK].
f
"Step Numberer 1" appears
To save the setting and return to the main menu,
f
push [RETURN] thrice.
The main menu appears.
2.4.3. Numberer 2
A second numberer can be saved on the Chipcard by a specialist vendor or the REINER
Service (imprint 00).
Settings according to numberer 1.
If the imprint 00 is not chosen or if no second numberer is saved on the Chipcard, the
message "At the moment not selectable" appears during configuration.
2.4.4. Changing Repeat Factor (Num. 1,2)
In the factory settings, the numberer switches on by one number after each print action
(1;2;3;4;5;6;....). To print several documents with the same number, a deviating repeat factor
can be set (repeat factor 02 leads to, e.g.: 1,1; 2,2; 3,3;....). The repeat factor can be set from
00 to 99. At value 00, the numberer will not count on. For manual counting on of the
numberer, see "Displaying numberer status and counting on manually", page 70.
Push [MENU].
f
"Imprint" appears.
Push [u] twice.
f
"Numberer/Fixed Number" appears
Push [SELECT].
f
"Numberer to zero (Num. 1,2)" appears.
Push [u] thrice.
f
"Changing Repeat Factor (Num. 1,2)" appears.
Push [SELECT].
f
The set repeat factor flashes.
Set desired repeat factor with the buttons [t] or [u].
f
To confirm the input, push [OK].
f
"Changing Repeat Factor (Num. 1,2)" appears.
To return to the main menu,
f
push [RETURN] twice.
The main menu appears.
78