baltur TBG 35 220/60 Manual De Instrucciones De Uso página 57

OPERATING STATUS AND EQUIPMENT RESETTING
The equipment is equipped with 3-colour signalling integrated in the
reset button (A).
The multi-coloured indicator is the main element for displaying, activa-
ting and deactivating diagnostics.
r
esettIng the equIpment
To reset the equipment, press for 1" the remote reset button in panel (8)
or the button on equipment (A).
The equipment is only reset if:
• all phase line contacts are closed
• no under-voltages are present.
Two diagnostic modes are possible:
1 visual: function indication or fault diagnostics
2. with interface: in this case, interface OCI400 and software PC ACS410 are required
d
IagnostIcs symbols
During normal operation, statuses are indicated in the form of colour codes as shown in the table.
c
ommand and control devIce status IndIcatIon
Condition
Waiting conditions TW, other intermediate conditions
Ignition phase
Correct operation, current strength of flame detector above the minimum
allowed
Incorrect operation, current strength of flame detector below the minimum
allowed value
Decrease in power supply voltage
Burner shut down condition
Fault indication (see colour key)
Extraneous light upon burner start-up
Quick flashing for diagnostics
NO LIGHT. RED.
0006160660_202402
Operating position
Diagnostics
Colour code table
xxxxxxxx
xxxxxxxx
xxxxxxxx
xxxxxxxx
xxxxxxxx
xxxxxxxx
.
YELLOW. GREEN.
Operating position
PC interface / diagnostic
analyser
> 3 s
EK
Colour sequence
. . . . . . . .
ENGLISH
A
8
Colours
No light
Intermittent yellow
Green
Intermittent green
Alternating Yellow
and Red
Red
Intermittent red
Alternating Green and
Red
Quick flashing red
15 / 40