Publicidad
Idiomas disponibles
Idiomas disponibles
ES EN
WARNING
Never mount a new chain on a worn sprocket or self-aligning ring.
OIL PASSES - The oil passages in the bar pad must be cleaned to ensure proper lubrication of the bar and
chain during operation. This can be done by using a soft wire small enough to insert into the oil discharge
hole.
Note: The condition of the oil lines can be easily checked. If the oil lines are clean, the chain will automatically
emit a stream of oil within a few seconds of starting the saw. Your saw is equipped with an automatic oiling
system.
CHAIN MAINTENANCE INSTRUCTIONS
- Unless you have specialised experience and training in dealing with kickback (see safety precautions),
always use a low kickback saw chain, which significantly reduces the danger of kickback. Low kickback
saw chain does not completely eliminate kickback. A low kickback chain or "safety chain" should never be
considered total protection against injury.
- A low kickback saw chain should always be used in conjunction with other kickback protection devices
such as the chain brake/hand guard supplied with your unit. Always use a replacement saw chain designed
as "low kickback" or a saw chain that meets the low kickback performance.
- A standard saw chain (a chain that has no protective links to reduce kickback) should only be used by an
experienced professional chain saw operator.
WARNING
Always wear protective gloves during maintenance operations. Do not carry out maintenance work
when the engine is hot.
CHAIN SHARPENING
The chain pitch is 3/8" LoPro x .050".
Sharpen the chain using protective gloves and a 3/16" (4.8mm) diameter round file.
Plug-in blower/vacuum cleaner 3000w
MOBICLEAN
29
Publicidad
