RIDGID R4041 Manual Del Operador página 12

ASSEMBLY
„ To adjust the height of the stand, move each adjustable
foot up or down until the hole in the leg is aligned with
one of the holes in the foot. Secure the feet in place using
height adjustment pins with bales.
NOTE: Make sure the feet are positioned at the same
height to ensure stability.
PLACING THE WATER TRAY ON THE STAND
See Figure 9.
„ Place stand on level ground and line up channels under
the tile saw water tray with the supports on the stand.
Carefully set the water tray onto the stand.
NOTE: It may be easier to fit the water tray onto the stand
if the stand is not opened fully. Slightly tilt one side of the
water tray as you set it onto the stand. Ease the other
side of the water tray down until it sits on the stand and
allow the stand to open as the water tray is fully seated.
HEIGHT
ADJUSTMENT
PIN
12 — English
POSITION HOLES
CHANNEL
Fig. 8
SUPPORT
Fig. 9