Publicidad
Idiomas disponibles
Idiomas disponibles
ADJUSTMENTS
WARNING:
Before performing any adjustment, make sure the
tool is unplugged from the power supply and the
switch is in the OFF position. Failure to heed this
warning could result in serious personal injury.
The saw has been adjusted at the factory for making very
accurate cuts. However, some of the components might
have been jarred out of alignment during shipping. Also,
over a period of time, readjustment will probably become
necessary due to wear, and/or transport.
Do not start any adjustments until you have checked with
a square and made test cuts to be sure adjustments are
needed.
TO SQUARE THE CUTTING WHEEL TO THE
TABLE
See Figures 38 - 40.
Do not loosen any screws for this adjustment until you
have checked with a square and made test cuts to be sure
adjustments are necessary. Once the screws are loosened,
these items must be reset.
„ Unplug the saw.
„ Using the hex key, loosen cap bolts on the left rail.
„ Place a framing square against the fence and the flat part
of the wheel.
„ Make adjustments and tighten bolts securely.
„ Move sliding table through full range of travel, to check
for square. Make adjustments again, if necessary.
„ Check distance of rails at the front and the rear. Distance
between inside rails should be 12-7/16 in.
„ Visually check that blade is centered in 0˚ slot.
„ After all necessary rail adjustments have been made
tighten the hex bolts securely.
CAP
BOLTS
26 — English
6 MM
HEX KEY
FRAMING
SQUARE
Fig. 38
12-7/16 IN.
(316 MM)
Fig. 39
0˚ SLOT
Fig. 40
Publicidad
