RIDGID R4041 Manual Del Operador página 27

ADJUSTMENTS
TO ADJUST SLIDING TABLE
See Figures 41 - 42 .
If the table doesn't slide smoothly, seems too loose on the
rails, moves side to side, or is visibly off track adjustments
may be required.
To adjust if the table is loose:
„ Insert hex key to hold the set screw in place and loosen
the self-setting bolt on the lower roller.
„ Once loosened, roller should touch the rail.
„ Insert hex key to hold the set screw in place and use a
wrench to tighten. Repeat for each roller as required.
NOTE: Check that all rollers are rolling properly after
each adjustment.
DEPTH STOP ADJUSTMENTS
See Figure 43.
The depth stop limits the cutting wheel's downward travel.
It allows the wheel to go below the table enough to maintain
full cutting capacities. The depth stop is factory set to provide
maximum cutting capacity for the wheel provided with the
saw. Make adjustments if needed.
„ Unplug the saw.
„ To adjust the depth, loosen the wing nut located on the
depth stop.
„ Turn the depth stop knob. Set the wheel to the correct
cutting depth (wheel just below the table surface). Lower
the cutting wheel to the table to check wheel clearance.
„ Readjust if necessary.
„ Tighten the wing nut.
SLIDING
TABLE
SELF-SETTING
BOLT
SET SCREW
LOWER CAM
ROLLER
GROOVE
UPPER CAM
ROLLER
RAIL
Fig. 41
SET SCREW
DEPTH
27 — English
LOWER CAM ROLLER
ADJUSTMENT
STOP
KNOB
SELF-SETTING
BOLT
Fig. 42
WING
NUT
Fig. 43