RIDGID R4041 Manual Del Operador página 18

ASSEMBLY
„ Lock the rip fence securely to the table by pushing the
locking handle down.
INSTALLING THE MITER GUIDE
See Figure 22.
The miter guide can be used from either the left or right side
of the cutting wheel.
NOTE: The miter guide cannot be installed until the drop
fence is in the raised position.
„ Fully raise the drop fence.
„ Place the slot on the underside of the miter guide on the
sliding table fence.
„ Lock the miter guide securely to the table by turning the
miter guide knob clockwise.
To adjust angles:
„ Loosen the miter guide knob.
„ Set to the desired angle by moving the guide left or right.
„ Tighten the knob securely.
„ Filling/changing the water reservoir
FILLING/CHANGING THE WATER
RESERVOIR
See Figure 23.
„ Install drain cap.
„ Fill the water reservoir with clean tap water to the fill line.
Do not fill past the "maximum" line on the tray.
To change reservoir water:
„ Unplug the saw.
„ Remove the drain cap and empty waste water into a
bucket. Do not allow the water to splash onto the ground
or around the machine.
„ Rinse the water reservoir thoroughly.
„ Discard the waste water in accordance with local
regulations.
„ Replace the drain cap and refill tray with clean water.
NOTE: Drain fits standard size garden hose.
MITER
GUIDE
DRAIN
18 — English
TO LOOSEN
TO TIGHTEN
CAP
MIN WATER
FILL LINE
MITER GUIDE
KNOB
DROP FENCE
Fig. 22
WATER
RESERVOIR
MAX WATER
FILL LINE
Fig. 23