Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY
INSTALLING THE FRAME
See Figure 12.
„ Carefully lift the frame assembly over the water tray, as
shown.
„ Insert heavy duty tab into the slot on water tray.
„ Lower the water tray frame into place on front of the
water tray.
INSTALLING MOTOR HEAD ASSEMBLY TO
FRAME
See Figure 13.
„ Align the holes in the motor head assembly with the holes
on the frame.
„ Lower the motor head assembly onto the posts.
„ Thread socket head screws through motor head assembly
and into holes on frame.
„ Tighten screws using the 6 mm hex key (provided).
NOTE: Wrench storage is located in the back of the mo-
tor head assembly.
WRENCH
STORAGE
TAB
SLOT
POSTS
WATER
TRAY
MOTOR HEAD
ASSEMBLY
SOCKET HEAD
SCREWS
FRAME
„ Lift the edge of the frame and attach the water hose to
the pump elbow.
„ Rest the pump power cord and water hose in the notches
provided on the water tray.
„ Connect the pump power cord to the motor head power
cord. Check that the rubber boot is pulled over cord
connection to help keep water off the plug.
NOTE: The pump turns on when the motor is turned on.
Let the cutting wheel build up to full speed and wait for
the wheel to get wet before moving the material into the
wheel.
PUMP POWER
CORD
WATER HOSE
Fig. 12
14 — English
RUBBER
BOOT
PUMP ELBOW
Fig. 13
Publicidad
