Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY
INSTALLING WATER TRAY EXTENSION
See Figure 19.
„ Standing at the back of the saw, hold the water tray ex-
tension with the tray tabs toward the slots.
„ Tilt the tray and slip the tray tabs between the frame top
and frame bottom. Tray should be over pump power
cord and water hose.
„ Once the extension slides into place, lower until the tray
tabs fit into the holes under frame.
„ Lower the tray support on the bottom of the water tray
extension to rest on the crossbar of the stand.
ADJUSTING THE DROP FENCE
See Figure 20.
The drop fence can be raised or lowered to accommodate
either the rip fence or the miter guide.
CAUTION:
Always secure the sliding table in its rear, locked
position before lowering the drop fence. Failure to
do so could create a pinch hazard between the
drop fence and the front frame support.
To lower the drop fence to use the rip fence:
„ Unlock the levers as shown.
„ Loosen the drop fence position by pulling outward.
„ Fully lower the drop fence and push back toward the saw
table to set in position.
„ Relock the levers to hold firmly in place.
To raise the drop fence to use the miter guide:
„ Unlock the levers as shown.
„ Loosen the drop fence position by pulling outward.
„ Fully raise the drop fence and push back toward the saw
table to set in position.
„ Relock the levers to hold firmly in place.
NOTE: The drop fence will only lock in the fully raised or
fully lowered position. Do not attempt to lock the levers if
the drop fence is not in one of these positions.
INSTALLING THE RIP FENCE
See Figure 21.
The rip fence can be used from either the left or the right
side of the cutting wheel.
NOTE: The rip fence cannot be installed until the drop fence
is in the lowered position.
„ Lower the adjustable drop fence.
„ Loosen the rip fence by lifting the locking handle.
„ Hook the end of the rip fence onto the saw table as shown
and lower the other end over the drop fence.
„ Check for smooth gliding action.
„ Position the rip fence the desired distance from the blade.
WATER
TRAY
TRAY TAB
WATER TRAY
EXTENSION
17 — English
FRAME
TRAY
SUPPORT
STAND
CROSSBAR
DROP FENCE
LEVERS
RIP FENCE
SAW TABLE
TRAY TAB
Fig. 19
Fig. 20
LOCKING
HANDLE
Fig. 21
Publicidad
