Fiorenzato XGi Serie Manual Del Usuario página 34

Series
1
2
Fig. 5
3.5 Residual risks
Fiorenzato M.C. S.r.l. has taken all necessary precautions during the design phase to
ensure that the grinder-doser can be used under the safest possible conditions. However,
during installation, cleaning and maintenance of the appliance, there are still some
residual risks that cannot be eliminated. Their effects can be prevented by appropriately
training the user in accordance with the provisions set out in the table below.
For each residual risk, provisions are indicated to limit and/or eliminate the extent of
individual risks.
Residual risk Present during:
Handling the appliance
when:
• Unpacking.
Bruising and/or
• Installing.
crushing of the
• Handling the
upper and lower
appliance to clean
limbs due to the
the surface on which
weight of the
it stands.
appliance.
• Connecting and
disconnecting the
power supply cable.
Electrocution
Fiorenzato | Series_00 Ed. 04/2022
EN
2
1
Fig. 6
Provisions for reducing the risk
• Grip the appliance fi rmly
before handling it.
• Make sure you have enough
space to handle the appliance
safely without hitting any
obstacles.
• Use non-slip gloves if
necessary when handling the
grinder-doser.
• Check the condition of the
power cable frequently and
replace it when it appears to
be deteriorated or damaged.
• Make sure that the switch is in
the "O" (OFF) position before
connecting the power cable to
the grinder-doser.
13 / 49
EN
3.6 Warning labels attached to the machine
An adhesive label indicating the danger of electrocution is attached to the bottom of the
grinder-doser near the power cable (see Fig. 7) The label indicates the presence of live
components inside the machine body.
ATTENTION! It is forbidden to remove the bottom cover when the
plug is connected to the power socket. All electrical maintenance work
(e.g. replacement of a damaged cable) must be carried out by qualifi ed
technicians when the appliance is disconnected from the mains power supply.
4 INSTALLATION
ATTENTION! Please read the following instructions carefully before
installing and operating the appliance.
4.1 Storage
If the appliance is not immediately installed where it is to be used and it is necessary
to store it temporarily, it should be put in a safe place that meets the following
requirements:
• the place chosen for temporarily storing the appliance should be a closed
environment, protected from the sun and bad weather conditions;
• the temperature of the storage location must be between 5°C and 40°C, with a
relative humidity of between 30% and 90%;
• if the appliance is to be stored for a long time before being installed, it should be kept
in its original packaging to ensure better protection.
14 / 49
Series
Fig. 7
Fiorenzato | Series_00 Ed. 04/2022