Ingeteam RAPID 60 Manual De Instalacion Y Uso página 36

Ingeteam
6. Installing the unit
Before installing the unit, the packaging must be removed, taking special care not to damage the housing (see
section „4.2. Unpacking").
Check that there is no condensation inside the packaging. If there are signs of condensation, the unit must not be
installed until you are sure it is completely dry.
CAUTION
All installation operations must comply with current regulations.
All operations involving moving heavy weights must be carried out using the required mechanical means (crane,
hoist, etc.).
6.1. General requirements for installation
The environment of the unit must be appropriate, meeting the guidelines described in the
section so that it is possible to open the doors and perform maintenance work.
The image shows the opening of the front door.
The opening angle of the door is up to 110º. However, a lower opening angle is permitted. At least 90º for
maintenance work.
The charger has a system that locks the door in the fully open position, preventing it from closing involuntarily
while work is being carried out inside the unit.
36
110°
Installing the unit
„5.1. Environment"
300000772 - Monterings- och bruksanvisning